Watkins HotSpring Bedienungshandbuch PDF herunterladen (Seite 5)

Install the FreshWater

AG+

1 Drain and refill your spa. Balance water per spa manufacturer

guidelines.

2 Install the FreshWater

AG+

after water is balanced. Refer to

Assembly and Installation Diagrams below for instructions regarding

your particular model’s installation.

3 Superoxidize the spa water with an EPA registered source of chlorine

according to manufacturer's instructions to burn off contaminants

and activate cartridge.

• Add 1.5 tablespoons of dichlor

to spa per 250 gallons (approx.

1000 liters).

• Note: 1.5 tablespoons is approximately 3/4 oz or 24 grams.

• Do not enter the spa if the free available chlorine residual is over 5 ppm.

Important: Initial superoxidation with dichlor

is required to burn off

contaminants and activate cartridge.

4 Run spa according to recommendations supplied to you by the

manufacturer of your spa.

Sodium dichloroisocyanurate dihydrate

ASSEMBLY AND INSTALLATION DIAGRAMS

The FreshWater

AG+

comes in two parts.

The main body (A) and the handle (B).

1 Attach the handle to the main body to create a single device as

shown.

Note: The FreshWater

AG+

is designed to fit most portable spas. Watkins

Manufacturing Corporation assumes no liabilities for the product if

installed in any way other than the methods described in this manual.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Watkins HotSpring Bedienungshandbuch Seite 5